The independent heating and cooling company across Hampton Roads and coastal Virginia
Gas Furnace Repair in Richmond, VA
If you smell gas, get everyone out of the house first, call 911 or the gas utility from outside, and only then call us. With that said, gas furnace repair in Richmond is steady work for us all winter: ignitors that glow but never light, flame sensors coated enough to drop out mid-cycle, pressure switches held open by a blocked flue, inducer motors screaming on startup. We test the sequence in order instead of guessing at parts. Call us or fill in the quote form and describe what you heard.
Call (888) 381-2953- A real person answers
- Open 7 days
- Written quote before work starts
Taking calls until 5:00 PM ET
Why Richmond homes end up needing this
- Nothing happens at all when I turn the heat on Thermostat, control board, transformer or tripped breaker on the circuit
- There is a loud bang when the burners light Delayed ignition from a weak ignitor or dirty burners, worth looking at soon
- Some rooms stay cold no matter what Blower or duct airflow problems, closed vents or a failing motor capacitor
What a gas furnace repair actually involves
A gas furnace has to prove several things before it will run, and any one of them can stop the heat. We start with the call for heat at the thermostat, then follow the sequence through the control board, inducer, pressure switch, igniter, gas valve and flame sensor. Once burners light, we watch how the unit behaves over a full cycle instead of leaving after the first flame. Plenty of failures only appear a few minutes in, when a limit trips or the blower quits early.<br><br>Diagnosis first, parts second.
What we check on the unit
We check the flame sensor and igniter, the gas valve and manifold, pressure switch and hose for blockage, the inducer motor, the blower motor and capacitor, limit switches and the control board. We inspect the heat exchanger for cracking and look at the flue and venting, which matters in older homes across the region where terminations get blocked. Return air and duct condition get a look too. In damp crawlspaces the ductwork and the furnace cabinet both take a beating, and that shows up as poor airflow.
Richmond coverage
From Richmond we also cover Henrico, Chesterfield, Glen Allen, Midlothian, Short Pump, Bon Air, Mechanicsville, Hopewell and Petersburg.
- 23219
- 23220
- 23221
- 23222
- 23223
- 23224
- 23225
- 23226
Related furnace repair work in Richmond
What every visit includes
The quote comes first, in writing
Covering 147 cities across Washington DC, Delaware, Maryland and 5 more.Phones answered by people
Open 7 days, 8:00 AM to 5:00 PM ET.All major brands serviced
Carrier, Trane, Lennox, Goodman and more. We are not an authorized dealer for any of them.Gas Furnace Repair in Richmond — quick answers
My furnace lights then shuts off after a minute. What is that?
Usually a dirty flame sensor, a limit trip from restricted airflow, or a venting problem. Change the filter and make sure supply vents are open. If it keeps cycling, book a heating repair visit so we can watch the full sequence.
Should I keep resetting the furnace when it locks out?
Once is reasonable. Repeated resets are not. A lockout means the control board detected a fault, often related to gas, flame or venting, and forcing it to retry can make things worse. Call us instead.
How soon can you get to my house in Richmond?
Call us and we will give you a straight answer on the next available window rather than a vague promise. Summer heat waves and the first real cold snap are our heaviest stretches, so same-day slots fill early in the day. If you are without cooling or heat, say so when you call and we will treat it as urgent. While you wait, you can check the thermostat batteries and settings, look for a tripped breaker, and change a clogged filter.
How it works
- Step 1
Tell us the symptom
Call or fill in the quote form. We ask what changed, when it started, and what the thermostat reads against the actual room temperature. That short conversation tells us what parts to load on the truck.
- Step 2
We diagnose on site
A technician checks the thermostat, the electrical side, airflow through the filter and coil, refrigerant behaviour and the outdoor unit. You get a plain explanation of what failed and why, before any work starts.
- Step 3
Repair and verify
We make the repair, then run the system through a full cycle and measure temperatures at the supply and return. If something upstream caused the failure, we tell you so it does not repeat.
- A real person answers
- Open 7 days
- Written quote before work starts
Why homeowners call us
- We know salt airCoastal homes lose condenser coils to salt corrosion years before inland systems do. We look for fin damage and pitted line sets on every visit, because a clean-looking unit can still be shedding capacity from the outside in.
- Humidity is part of the jobHurricane-season air loads a system in ways a temperature reading will not show. If your house feels clammy at 74 degrees, we look at run times, airflow and drainage rather than just adding refrigerant and leaving.
- Crawlspace realitiesHigh water tables mean wet ground under ductwork, rusted plenums and condensate lines with nowhere good to drain. We check what is happening under the floor, since that is often where comfort problems actually begin.
- Straight answersWe tell you what failed, what it will take to fix, and whether a repair makes sense on an older system. No pressure to replace something that has honest years left in it, and no vague diagnosis.
- All major brands, gas & electricIndependent service on Carrier, Trane, Lennox, Goodman, York and the rest.
- Straight answersWhen a replacement beats a repair, we tell you, sometimes before we roll a truck.
Gas Furnace Repair in Richmond
One visit tells you where you stand
Describe the system and your ZIP. The written quote comes before any work starts.
- A real person answers
- Open 7 days
- Written quotes
- All major brands
- Gas & electric
Rather not call? Get a free quote →